Looking for a New System?
Call us today for a Free estimate appt.

Service and Diagnostic
We have competitive rates for Diagnostic fees:

• Milwaukee county, Racine and Kenosha counties west of Hwy 75 $89
• Racine and Kenosha $69
• Become an EPA member and save! it's only $59 then
• 24 hour Emergency Service No Extra Cost

System Tune-up Services
Winter special for $69.95 (Expires March 31, 2008) Oil Fired systems are priced differently, please call for current pricing.

Furnace Points of Inspection

• Electronically testing airflow passages for CO (Carbon Monoxide)
• Vacuum, clean and brush heat exchanger
• Remove smoke/flue pipe and vacuum if nessasary
• Tighten all wire connections for safety
• Clean blower housing and remove all debris
• Test Thermostat for proper anticipator and cycle
• Test Fan and furnace limits for safety
• Inspect for dangerous combustible materials
• Check temperature rise accross heat exchanger
• Lubricate all moving parts
• Perform operating cost analysis
• Remove burners and clean
• Inspect heat exchanger for cracks, holes, or separations
• Clean or replace furnace filter*
• Electronically check for natural gas leaks
• Adjust fan belt (if needed)
• Inspect thermocouple/igniter for proper burn
• Check amp draw on blower motor
• Inspect flue or chimney for blockage
• Measure manifold gas pressure
• wipe down furnace exterior

*Excludes Media, washable, and electronic style filters.

Boiler Points of Inspection

• Electronically test for CO (Carbon Monoxide)
• Vacuum, clean and brush heat exchanger
• Remove smoke/flue pipe and vacuum if necessary
• Tighten all wire connections for safety
• Check for proper component locations
• Check system operating pressure and swing
• Check and lubricate boiler pump
• Test thermostat for proper anticipator and cycle
• Test aqua-stat for safety
• Inspect for dangerous combustible materials
• Check temperature rise across heat exchanger
• Lubricate all moving parts
• Perfor operating cost analysis
• Remove burners and clean
• Inspect heat exchanger for cracks, hole, or separations
• Electronically check for natural gas leaks
• Inspect thermocouple/igniter for proper burn
• Check amp draw on pump motor
• Inspect flue or chimney for blockage
• Measure/adjust manifold gas pressure
• Wipe down boiler exterior

A/C Points of Inspection

• Clean outdoor coil
• Tighten all wire connections for safety
• Clean blower housing and remove all debris
• Check wet and dry bulb temperatures in the home
• Check subcool
• Check suction pressure
• Check temperature drop across coil
• Lubricate all moving parts
• Perform operating cost analysis
• Check Relays and or contactors for pitted contact points
• Check amp draw on motors
• Clean or replace furnace filter*
• Check refrigerant charge
• Adjust fan belt (if needed)
• Check superheat
• Check head pressure
• Check for airflow restrictions
• Inspect duct work for proper CFM
• Clean drain lines and fittings

*Excludes Media, washable, and electronic style filters.